MagNet for SOLIDWORKS
During this introductory training course, students will learn how MagNet for SOLIDWORKS can be used to simulate and analyze their transformer, actuator and other devices.
Intended for new users who seek an introduction to the key features: problem setup, solving techniques, post-processing and how to avoid common pitfalls.
The last part of the course is an open lab session where attendees are encouraged to practice and seek advice on their specific application. A team of experts will be available to assist and answer questions on an individual basis.
|None scheduled at this time. Please contact us by email for more information about upcoming courses.||
300 rue Léo Pariseau
Montreal, QC H2X 4B3
If you have any questions regarding this platform support change and the end of life for 32-bit software, please contact either Customer Support or your local representative.
The cost per attendee for this course is $1,600.00 USD.
If you have purchased a perpetual license of MagNet for SOLIDWORKS within the last 12 months, you are entitled to a free training course credit for one attendee. Please note that payment is due before the course begins
For more information, please contact your local Infolytica Corporation representative or email us firstname.lastname@example.org.
TERMS AND CONDITIONS
The registration form must be received 14 days prior to the start of the course.
Please note that payment is due before the course begins. Do not make travel arrangements or payment until your registration has been confirmed.
We reserve the right to cancel or change the date of the training course.
You may withdraw from the course with no penalty up to 14 days before the published date of the course. Cancellation must be made by means of written notice to Infolytica Corporation.
This course and the training material distributed are copyrighted and cannot be used in whole or part without written permission from Infolytica Corporation.