MagNet 2D/3D Introductory Training Course





February 16-18, 2016

May 17-19, 2016

August 16-18, 2016

November 15-17, 2016

Infolytica Corporation

300 rue Léo Pariseau

Montreal, QC H2X 4B3

During this introductory training course, students will learn how MagNet 2D/3D can be used to simulate and analyze their motor, transformer, actuator and other devices.

Intended for new users who seek an introduction to the key features of MagNet: problem setup, solving techniques, post-processing and how to avoid common pitfalls.

The last day of the course is an open lab session where attendees are encouraged to practice and seek advice on their specific application. A team of experts will be available to assist and answer questions on an individual basis.


  • Geometric modeling
  • Material modeling
  • Boundary conditions
  • Coils and circuits
  • Meshing and Mesh Adaption
  • Solving and Post-processing
  • Parameterization
  • Scripting
  • 2D vs 3D modeling


The cost per attendee for this course is $2,400.00 USD.

If you have purchased a perpetual license of MagNet within the last 12 months, you are entitled to a free training course credit for one attendee. Please note that payment is due before the course begins


For more information, please contact your local Infolytica Corporation representative or email us info@infolytica.com.


The registration form must be received 14 days prior to the start of the course.

Please note that payment is due before the course begins. Do not make travel arrangements or payment until your registration has been confirmed.

We reserve the right to cancel or change the date of the training course.

You may withdraw from the course with no penalty up to 14 days before the published date of the course. Cancellation must be made by means of written notice to Infolytica Corporation.

This course and the training material distributed are copyrighted and cannot be used in whole or part without written permission from Infolytica Corporation.