--%> --%>

MagNet for SolidWorks Application Pages

Page 1 2 
Sort by: Date
Title

Rare Earth MRI Magnet Assembly

Magnetic Resonance Imaging [MRI] is a non-invasive mechanism for assessing the nature of materials. Whether one desires to monitor the fat content in a cookie mixture, or review potential structural damage to a human joint, MRI equipment is readily available.

Link to example

Voice Coil Actuator

The Voice Coil Actuator is a high precision motion control device. These actuators are capable of both low speed, low acceleration movements as well as high speed, high acceleration movements. Programmable servo controls allow the actuator to carry out a move profile as required. Its primary advantage over other motion control devices is that the load is directly coupled to the actuator.

Link to example

Bath Plate with Two Holes (T.E.A.M. Problem 3)

The Bath Plate problem consists of a conducting ladder with a current driven coil hovering over it. The problem consists of calculating the magnetic field along the center vertical line of the model just over the surface of the plate.

Link to example

Asymmetrical Conductor with a Hole (T.E.A.M. Problem 7)

This problem consists of a thick aluminum plate with a square hole placed to the side. A current driven coil is placed unsymmetrically over the aluminum plate. A sinusoidal current is used to drive the coil at two different frequencies.

Link to example

The Bath Cube Experiment (T.E.A.M. Problem 5)

Four aluminum blocks are spaced symmetrically between the poles of an electromagnet. A MMF of 1000 A-Turns is applied between the upper pole and the lower pole. The magnetic field is then measured along contours on the surface of the lower pole.

Link to example

Rectangular Slot in a Thick Plate: a Problem in Non-destructive Evaluation (T.E.A.M. Problem 15)

In order to detect flaws, sensor problems require the accurate calculation of induced eddy currents. MagNet for SOLIDWORKS AC Time Harmonic solver automatically calculates these eddy currents. The results presented compare published experimental data demonstrating the accuracy of the software.

Link to example

3-D Static Force Benchmark (T.E.A.M. Problem 20)

This rig is made from a steel center pole and yoke. The center pole is surrounded by a copper coil excited by a DC current. This problem shows the ability of MagNet for SOLIDWORKS to solve Static Magnetic Problem involving force and magnetic field calculations.

Link to example

Nonlinear Time-Transient in Switched Reluctance Motors (T.E.A.M. Problem 24)

This is a test rig configuration similar to a switched reluctance machine. It is made of solid medium-carbon steel and mounted in a nonmagnetic cage which can rotate about a stainless steel shaft. This is a nonlinear transient problem, which was simulated using MagNet for SOLIDWORKS transient solver.

Link to example
Page 1 2